DIY Cat Bed Tutorial: Make Your Cat a Cozy Bed from a Basket

How do you make a simple cat bed for your feline friend? It’s easy—all you need is a woven basket, plywood, and some creativity and you’ve got the perfect place for kitty to rest and relax. Follow these steps:

DIY Cat Bed Directions:

1. Mark the Basket Size

Place the basket onto the plywood. Using a pencil, mark the outline of the basket on the plywood.

2. Cut the Plywood

Using a jigsaw, cut just inside the marked outline to allow the panel to find inside the basket. Check for a snug fit inside the basket—trim as needed.

Jenn Largesse

Trace the cutout onto a new piece of plywood, and then cut a second circular piece to create two levels.

3. Mark the Opening on the Upper Level

Using a round item (like the lid of a pot), mark the ends of a 10-inch opening about 2 inches from the edges of the circle. Using a ruler, draw a line between the circular ends to complete the outline of the opening.

4. Cut the Opening

Using a drill/driver fitted with a paddle bit, create a hole inside the marked opening. Insert the blade of the jigsaw into the hole, and then cut the opening. Sand the edges of the plywood pieces smooth with a sanding sponge.

5. Cut and Secure the Uprights

Using a miter saw, cut the 1×4 boards to a height about four inches less than the height of the basket. Rest the top plywood cutout onto a paint can and blocks to allow the boards to stand upright beneath it. Apply glue to the top edge of the boards, and then position them along the edges of the plywood. Nail through the plywood and into the boards to secure them in place. Flip the assembly. Apply glue to the remaining end of each board. Position the lower plywood circle onto the boards. Secure the plywood to the boards with nails.

6. Cut an Opening in the Basket

Using painter’s tape, mark off an 8-inch square opening near the base of the basket. Cut the threads between the coils to separate the woven layers along the top and bottom of the opening. Cut a slit up the center of the opening. Fold the flaps inside the basket. Using hot glue and clamps, secure the flaps inside the basket. Add a stitch if needed. (Tip: flatten the crease with a clothes iron)

7. Insert the Assembly into the Basket

Lower the assembly into the basket. Position the assembly so that the opening in the basket is not obstructed by a board. Add a pet bed to the lower level and a blanket, carpet, or fabric to the upper level.


What You Need:

Tools

Materials

Cut List

  • 1 x 4 Uprights – 5 @ 10 inches (or about 4 inches less than height of basket)
  • ¼” Plywood Levels – 2 @ 22” diameter circle (Cut to circle, sized to inside dimensions of basket)

Source link